Brief introduction

DIN Rail Industrial PLC Ethernet Bridge is a powerline telecommunication product which developed by WonderTek Technology (KunShan) Co.,LTD., it supports HomePlugAV2  protocol.  At present, it has been widely used in railway, mineral, industrial communication, airport, subway, coal mine, intelligent storage, industrial automation control, automatic garage and other wired or sliding contact line and many other sites.
 

1.1 Highlight

1.1.1 Technical parameters            
l Support HomePlug/HomePlugAV2.
l Industrial DIN rail style installation.
l Actual bandwidth up to 550Mbps.
l The maximum transfer distance up to 800 meters.
l Self-adapt the rate.
l One Domain Master can manage 127pcs End Point.
 
1.1.2 Manageability
l Support Remote Firmware update(TR069).
l 802.3D Ethernet Bridge.
l 802.1Q VLAN.
l Quality of Service(QoS) .
l IGMO(IPv4)Snooping&MLD(IPv6)Snooping.
 
1.1.3Operating environment
l Working temperature:  -40℃-85℃.
l Operating humidity: 10%-85% no condense.
l Storage humidity:5%-90% no condense.

1.1.4 Design standards
IEC 60529                   IEC 50022
IEC 60068-2-6             MIL-STD-810G
HomePlugAV                HomePlugAV2
 

Specification

1.2 Features

(1) Packet loss：≤0.1%（100M,load 70%）.
(2) Support 7*24 hours all weather operation.
(3) Hardware watch dog function.
(4) PING≤2MS.
 

1.3 Immunity of ESD

The testing voltage which the device should be beared: ±6kV direct Discharge, ±8kV air discharge;
Discharge number in Each sensitive testing point: Plus-n-Minus 10 times each;
Every time the discharge interval is 1 s, according to B/T 17626.2-2006.
 

1.4 Immunity of electrical fast transient impulse group(Common mode)

The testing voltage which the device should be beared:
between the power supply voltage port and ground: ±2.0kV; 
between signal circuit and ground: ±1.0kV;
repetition frequency: 5KHz, test duration: 1 min/ time; 
testing times: Plus-n-Minus 5 times each.
According to GB/T 17626.4-2008.
 

1.5 Anti interference of surge impact

The testing voltage which the device should be beared: ±2kV; 
The interval of continuous impulses: 1min/time;
Test number: Plus-n-Minus 5 times each.
According to GB/T 17626.5-2008.(protection: all models protection and varistor series of discharge tube type)
 

1.6 Anti- vibration

Meet the demand of MX3 in TB1433(0-200Hz,2g acceleration,  maximum amplitude 7mm), interface with no loose, device with no Sealing off and drop in the test.
 

1.7 System Topology

Model: WD-1201M-DIN（T4）

 

 

Model: WD-1201M-DIN（V3）

 

Model: WD-1201M-DIN（D）

 

Product model selection: